Precautions For Stamping Parts

1. Semi-automatic and manual presses must be equipped with two-hand brake switches. It is strictly prohibited to press the switch with foot or one-hand start.
2. After the high impact is adjusted and the machine is pressed normally, close the sound insulation box (except for the case of product 8065 being inspected while packaging).
3. During continuous stamping, employees cannot take the product by hand within 1M of the press.
4. When the technician is on the mold adjustment machine, only one person can debug, not two people can debug.
5. The technician can only transfer the machine and feed the material outside the machine, and the distance is not less than 1M.
6. The screws must be locked when the formwork is erected, and the machine shall be shut down for 4 hours to check whether the screws are loose.
7. When the mold has problems in the production process and does not need to be unloaded, and is directly repaired on the machine tool, the power supply of the injection molding machine must be turned off first and the sign of being repaired must be hung on the power box before the mold can be repaired.
8. All tools shall be returned to the tool box after use, and shall not be placed on the machine table, so as to prevent the tools from falling and hurting people.
9. When the machine is not in production, cut off the power supply in time.
10. When short and small workpieces are needed, special tools shall be used instead of directly feeding or taking parts by hand.